Discussion Locked

SATA drive dropout

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

The System:
MSI KT6V-LSR motherboard
1gb Kingmax DDR 400
AMD Athlon XP 3200+
1 x 80gb Western Digital SATA
1 x 120gb Western Digital SATA
420w Thermaltake PSU
Windows XP Pro.

The Problem:
The 120gb SATA keeps dropping out. Windows explorer shows it as D and E drives but after a time it suddenly drops out. After reboot it comes back but as I and J drives.

Why is this happening and what can I do to resolve this problem?

10 replies

by cg it

might be your master slave settings on the HDDs. Microstar has noticed problems with other SATA drives that exhibit the similar problems and/or are not detected at all. notably the Seagate SATA drives. The solution to the problem was to ensure the master/slave configuration for the drives are properly configured. They should be either as a master or single and not a slave drive.

by willcomp

Assuming that drives are on separate SATA channels (how I would do it), you may have a faulty drive exhibiting random on-board electronics failures.

Try connecting problem child as only drive and see what happens. If it's a dud, failures will continue.

Dalton

by willcomp

Also change out signal cable and power connector. One or the other could have an intermittent short.

by willcomp

Hmmm, since you had already tried these, shows great minds think alike.

Only other possibility that comes to mind is a faulty mobo interface.

by daz'n'ash

Willcomp, been tehre tried that, the problem remains, albeit intermittent. Any other suggestions?

by a

SATA drives are only one per connection. There is no master or slave (or Cable Select) setting, and there is minimal to no configuration in the BIOS. They are fast and easy to install, plug and play, and most are hot swappable.

IF your motherboard supports Hot Swapping the drives, try unplugging one when it dies, and plug it back in. unplug DATA, POWER. Wait 30 seconds. Plug POWER, DATA, in that order. Or if you have one of the full size connectors that has data and power all in one, just unplug it and plug it back in.

Also, you can force drive letters in windows by going to COMPUTER MANAGEMENT in the start menu - accessories - system tools. You can make your drives any letters you want them to be. The default is float, so windows picks a letter. If you have one of those multi-format card readers, it may be conflicting for the lower letters causing the I & J problem. Those things can use up to 4 or 5 drive letters, generally one for each slot in the device.

You might also just have a bad drive. Try putting it into a different computer and see what happens.

A

This discussion is closed to new replies.