Discussion Locked

Saving current settings to modem NVRAM

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a 3COM Courier 56K modem modem. I am needing to set the S0 value to S0=1 so that the
modem will pick up on the first ring. I need
the command from the AT set to write my current
settings into NVRAM so that this S0 setting will
always hold on each power up. I know AT&W is
for writing the settings to NVRAM but this does
NOT hold them on this modem. Couriers must use a slight variation on the AT command set since ATi4 is what is needed to see current profile config versus the somewhat universal AT&V command.

5 replies

by alquinones

Funny you should ask because I was working on a client's Courier modem just today and I couldn't save any changes to any of the S registers. What I did do is moved the dip switch 5 on the bottom of the modem to the "OFF" position this will cause the modem to auto answer every time. AT&W is suppose to save/write any modem setting (according to 3Com). There must be something else.

by djent

A word of warning. Do NOT include the &w in your init string. The NVRAM has a finate # of write cycles, when they are expended you can no longer write.

This discussion is closed to new replies.