Discussion Locked

scan tak 2c flatbed scanner

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i have recently changed computers and now have a gateway e-1000 with 128mb ram 6gb hd and 200mhz processor with win 98. my scan tak 2c scanner that i connected to this computer is not being recognised and is not working. i had to get a 25pin male tomale adaptor so that i could connect it to the printer port on this computer. can you please advise as to what i need to do to get this scanner working. i have since gotten rid of my other computer. please respond to leacroftb@yahoo.com or call me at 407-375-0162. thanks

5 replies

by hrhold1

Sounds like you need the drivers so the system knows what to install. Go to http://www.driverguide.com/, use the public password & log-in: Drivers ; pass = All , if you need to log on. Search for your scanner driver. The site is simple to navigate and I have found the files there to be credible.

Once you have the drivers for your scanner, do Start/Control Panel/ Add New Hardware, let the system search, if it finds no new hardware it will tell you. Then you " Select from List" and choose your scanner or sub heading 'Scanners" and select "HAVE DISK", and direct the program to the source folder of the files, IF, the files did not come with a "self-Extractor". This should get you up and running.

Hope this helps; H

by albert franco ii

The clue that you had to buy an adapter made me think you have a SCSI interface and not a parallel port interface.

Sure enough...checking the web I found a description of your scanner:
Product Name: Spot ScanTak 2C Flatbed Scanner Platform: IBM PC/Compatibles

Software Bundle:
Spot Solutions Office Suite Bundle
Spot Studio Graphics Software

Accessories:
SCSI-II Interface Card
SCSI-II Cable
Power Cable
Documentation

Notice that this scanner has a SCSI II card and cable. DISCONNECT IT FROM YOUR PARALLEL PORT AT ONCE!!! THEY ARE NOT VOLTAGE COMPATIBLE!!!!

You need to try to get the SCSI card back from your old computer and install it and its drivers.

Your first challenge is finding a compatible SCSI card then you'll need to find the drivers if don't still have the original disks.

Good Luck,
Al Franco, II

This discussion is closed to new replies.