Discussion Locked

scanner & printer installation

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I installed a new scanner,visioneer 8100 onetouch, I have a HP 812 C printer, connected them as thy instructed, (I think)
but~ when I turn the scanner on, the printer says printer is not connected to computer.
I turn the scanner off, and I can print anything I want to. what did I do wrong?
I am running WI 98 had no problems with my old scanner, so ,I figure ,I did something wrong.
could someone tell me what?
thanks
Tanja

11 replies

by dmiles

Check your connections and make sure you have a good contact,connect scanner to computer port and then the printer to port on your scanner and then add drivers,check to make sure you have pinter installed thru the printers panel.

by tbradley

The problem is with the driver for the 812. It has been troublesome when connected to scanners, or external switchboxes.

Turn off bi-directional printing in your system BIOS, and in the C:\windows\system directory, you will find a file called
hpcfgXX.exe or very similar ( XX is ver # )

run this file, and turn off bi-directional printing in the driver software.

The problem you are having is that with the scanner turned on, your PC cannot receive back a "printer ready" signal from the 812, and not receiving it, says the printer is not there. When the scanner is turned off, the pc-scanner-printer connection appears as a single cable.

There may or may not be a setting in your new scanner software to allow a "pass thru", so the easiest solution is to turn off bi-directional for the printer.

by randycapped

make sure you have the parallel port mode on the right setting for the scanner like epp, ecp etc.
If you still cannot get it working you might have to get a parallel port card so you can connect both directly to the PC without having to chain them

by robbi61

And to add to the answers already given, don't forget to check and make sure your cable is ieee 1284 compliant. A scanner/printer set up requires a bi-directional cable.

by _tbond13

Thanks to all these great People for the help for my Printer/Scanner problem. after reading all 4 messages, I did that bidirectional, plus I downloaded a new Driver. made sure all is connected tight, and
yippee,,,, it works,

thanks,thanks,thanks

Tanja

This discussion is closed to new replies.