Discussion Locked

Scanner problems

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I received a Mustek scanner from one of my friends. I think the model number is 1200SP. It is pretty old. He said that I need a SCSI card to get it to work. Is there any way that I can get it to work without one if my friend is right?
Is there anywhere that I can find information about older Scanners and whatforth?

6 replies

by ozi eagle

Hi,

A couple of comments about issues I have encountered with older SCSI scanners.

The SCSI card may be an ISA bus and the software looks for specific locations, therefore PCI SCSI controller doesn't work with scanner software. Updates to the software are available, but at a cost.

By the time you purchase a SCSI card and software updates, you would most likely be able to buy a new scanner, they start at about $100.

by k3125

Thanks, I just bought a new one for about $150.
Saved myself alot of headaches.

by thechas

The Mustek 1200 SP does use the SCSI interface.

You MUST use a SCSI card to connect to the scanner.

As I recall, the SCSI card that shipped with many scanners was not a full function SCSI card and would only work with the scanner.

Also, you need the correct iteration of SCSI in order to connect to the scanner.

I suspect that this scanner runs on SCSI "1".
You want a "standard" SCSI card. Not ultra SCSI, or wide SCSI, or even SCSI II.

This is an older scanner. Mustek only has drivers for Windows 3.11, NT and 9X.
If you are running Windows 2000 or XP, you can't use this scanner anyway.

http://www.mustek.com/download/driv_scanr/english/sp35.html

I tend to agree with answer 1. By the time you add the cost of a SCSI card and cable, you should be able to find a clearance or refurbished scanner for about the same cost.

Chas

by k3125

Thanks, I just bought a new one for about $150.
Saved myself alot of headaches.

This discussion is closed to new replies.