Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Is it posable to replace Ultra SCSI 2 HDD with the newer HDD Rated at Ultra 160.
3 replies
by cbach1997
I would recommended it without a new 160 controller, these drives use a 68 pin interface, SCSI-2's use 50. So you need an expensive adapter cable that I haven't run into. Not to mention that if you got it to work, it would only function at the SCSI-2 data rate (I think it's 20MBit/sec).
So if you wanted to upgrade to a new 160 SCSI HD, I would get a new adapter. The Adaptec 29160 and 39160's all ship with a 68 and 50 pin interface for compatibility and full performance with both.
Hope this helps, and good luck
cbach1997@hotmail.com
by skippeck
Poster rated this answer
by skippeck
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies