Discussion Locked

SCSI Adapter and Scanner Installation

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

On my advise a client purchased a HP 7400C scanner over the web. They sent it to him with a USB lead, of no use as the client has WinNT. He does not want to pay out any more dosh over this.

I dug out an old Adaptec AHA-2940 card and went over to install it in his machine. I figured I would install the card and get the scanner to work with it. However on putting in the PCI card and starting the machine a message about the BIOS not installed came up. The machine seems to have recognised the card but the BIOS stop error still comes up. Pressing F1 to boot and installing the SCSI drivers I picked from the web, I rebooted the machine and got a BSOD. It only disappeared when I disabled the card in the BIOS, of course meaning I can't use it.
I tried looking through the Adaptec website, but I couldn't find any useful infomation, advice. Just an .exe bios upgrade with no advice on how to use.

Any ideas anyone? Will the scanner even work with this card?

Thanks

Fast_Losing_Credibility

3 replies

by allan

I have a 7400C & Adaptec 2940 working ok - i'm using win2k but it did work with NT with no problems. Have you configured the card OK, Ctrl - A at boot If I remember correctly, set the address for the scanner to a low speed, also check that you have a terminator. By the way the scanner should show as attached when the Adaptec BIOS loads. The only drivers you should need are the ones for the scanner with a 3rd party SCSI adapter.
Good Luck.

by v-gathara

I tried everything and concluded that the card was damaged. Changed it with another and it worked fine.

Thanks for this though

This discussion is closed to new replies.