5 replies
by pschuvie
Well a couple questions to get a better picture of what you have going.
What is the operating system that you are using?
What kind of SCSI card do you have in the system?
What kind of SCSI devices do you have on the card?
Have you loadedthe installation software that came with the scsi card?
Does the controller card show in your list of devices?
It sounds like you may have scsi support set in your bios, or that the scsi on board bios is showing that it sees the devices but you have not yet installed the SCSI into the operating system so there is no bridge between the BIOS the SCSI Controller and the OS.
Your answers will help in giving you additional assistance.
by technology
by dirk.deprest
Serveral SCSI-card are not seen by DOS, you must install drivers when you want them to work, for example ADAPTEC AHA-131 with RIAD 5 capabilities you can't see them in DOS, thats why if you whant to run a SCSI card with windows NT or 2000 you must press F6 at the beginning of the setup, you must first install the drivers for it
I hope I answered your question correctly
Regards
Dirk
by technology
by technology
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending