Discussion Locked

SCSI and IDE HDD

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I want to add an IDE HDD to a system with a single SCSI HDD. The system boots from the SCSI HDD at this time. One IDE channel is available for use on the system board. Can I add an IDE HDD as a slave and will the system still boot from the SCSI and operate properly?

3 replies

by techrepublic

Yes you can.
Just tell the BIOS / PROM not to boot from the IDE disk. It may even already be set that way.

by mark

Sure. Boot device is setup in the BIOS. Usually you press "Del" while the system is beginning to Boot. You can set it to boot from either HD. Usually it will have choices like SCSI, IDE-0, IDE-2, etc. The SCSI BIOS should have boot options too if there is more than one SCSI HD.

by sgt_shultz

yep. but it won't be a slave. it'll be the sole drive on that ide channel. most drives want to be configured as 'master' (jumper in the 'master' position) in that configuration. but western digital drives want to be configured as 'sole drive' which is no jumpers...if you get a hold of an ide cable that has splits in it and the word 'master' silked on it somewhere, you have a 'cable select' cable. in that case, configure your drive with the jumper on CS and place the drive on the 'master' position. make sure the ide controller is enabled in BIOS, turn on lba support. after installing, check to see that the bios detects it correctly. (if not look at possible cabling/jumpering problems). depending on your BIOS you may need to configure the 'slave' position on that channel to OFF. if you have an 'automatically detect ide devices' option in your BIOS, use that after you install the new ide drive.

This discussion is closed to new replies.