Discussion Locked

SCSI CARD

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
In Win98 2nd. I am trying to connect a CanoScan 300 flatbed scanner to my computer. The instant I connect the scanner cable to the computer SCSI the scanner shuts off as if a circuit breaker had tripped. I've tried two different SCSI's and get thesame results. I removed the SCSI card from the computer and with the scanner swtich on connected the cable to the SCSI and it shuts the scanner off. If make all the connections the I am not able to turn the scanner on at all; before or after the computer boots. Why

8 replies

by daz'n'ash

Try something simple to resolve this first. I would suggest you plug the scanner into a different power outlet from the mains electricity away from the computer. This can cause problems by having too many things plugged in with the same power outlet as the computer. I hope this works for you.

by jaynjoanne

Thanks to tuituckta@yahoo.com for your response. I've already tried that with no change. I even change my connection cable. Steps taken: with the computer off I connected the SCSI to the slot; boot up and SCSI was found and installed; then I installed the CanoScan 300 drivers from Canon Web page; turned off computer, connected scanner and turned on...scanner would not turn on. Through process of solving I discovered that the instant I plug the scanner into the SCSI, whether the computer is on or off, or the SCSI is in or out of the computer the scanner shut off. I've tried many ways with same result. Is there a way to test the scanner itself?

by jaynjoanne

Thanks to tuituckta@yahoo.com for your response. I've already tried that with no change. I even change my connection cable. Steps taken: with the computer off I connected the SCSI to the slot; boot up and SCSI was found and installed; then I installed the CanoScan 300 drivers from Canon Web page; turned off computer, connected scanner and turned on...scanner would not turn on. Through process of solving I discovered that the instant I plug the scanner into the SCSI, whether the computer is on or off, or the SCSI is in or out of the computer the scanner shut off. I've tried many ways with same result. Is there a way to test the scanner itself?

by daz'n'ash

Well, 2 things come to mind, one is to try it on another computer and see if it works, the other is if it is new and still under warranty, maybe try to exchange it for another one.

This discussion is closed to new replies.