Discussion Locked

SCSI hard drive setup and NT

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a new server, no OS installed, that has 2 scsi hard drives in it and I want to install NT4. The computer sees the hard drives but when I run NT4 setup it says there aren't any drives. I have never worked with scsi hard drives before and would like to verify what I need to do. I checked Seagate's site and downloaded disk wizard to set up the drives so NT4 setup can see the drives because I figure it is the same as new IDE drives and fdisk. My thought is that if when I turn the server on and it sees both hard drives and it says one is 0 and the other is 1, but NT4 setup doesn't see them that this is the problem and disk setup will take care of the problem. Is this correct or am I missing something?

5 replies

by alpha-male

The big thing to start with is to make sure you are successfully loading the drivers for your SCSI controller. If it loads automatically and still isn't working, try manually loading the latest drivers from the manufacturer.

Good luck!

by gaklim

During your setup, pay attention to the words at the bottom. It should display something like "Press to.....". At this time, press once. At a later part, it will prompt you for a driver for your SCSI card. Intall the correct driver andyou should be able to finish the installation.

by sue t

I tried both answers but I found that the only way I could get it to work was by booting to the setup diskettes that came with the NT4 CD. I don't understand it because according to the book and people I talked to I should not have needed to use the diskettes since the computer is capable of booting to CD but I also talked to one person who found this trick. Thank you.

This discussion is closed to new replies.