Discussion Locked

SCSI HDs are gone

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Running NT4 sp6a, PIII 450, 256ram, 1 ide hd (os), 2 scsi 2940u2w, @ card is attached to 3 scsi hd (36Gb@), for a total of 6 HDs (external tower). I installed nt4 successfully I setup raid 5 ok (disk admin.=ok). Next day 3 hd are gone (same scsi card), reboot, run diagnostics, all hd are there, run disk verification, all ok, reboot to nt, 3hd still gone, run scsi ... (control panel) 2 cards are there only 1 has hd's attached the other does not. Help... tks.

3 replies

by fn1

Today all HDs were ok, until one of them decided not to respond, I had to "restore" the raid 5, in order to get all 6 HDs again. It seems that the HDs are powering themselves off (it happened to two different HDs, and on both scsi controllers).

Is there anything to troubleshoot this problem or a setting to stop the HDs from powering off. (I have 5 IBM LVD HD's and 1 barracuda, 36Gb @)

Thank you

by djent

SCSI cable connections are critical, use a good contact cleaner, terminator may be bad, replace cable if needed. Intermitent problems are usually dirty connections.

This discussion is closed to new replies.