Discussion Locked

SCSI problem

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I needed access to a Compaq DeskPro EN 350. I did not have the hardware password so I reset it by moving the CMOS jumper on the motherboard. On startup, I see the following:

Adaptec AHA-2940AU BIOS v1.21
SCSI ID: LUN NUMBER #:# 4:0 -HP CD Writer 6020

SCSI BIOS not installed!

The system boots fine. The HP 6020 appears in My Computer but does not function.

I've tried reinstalling NT - no change.

I went into the SCSISelect utility but I really don't know much about it to see the red flag.

Any suggestions?

Rob

10 replies

by vertex

Do have the drivers for the SCSI card? On NT boot-up choose other profile and load the drivers from there.

by rmccabe

I loaded the latest drivers on install. I think the problem lies in the SCSI BIOS not loading but I have no expertise in this area.

by rmccabe

I just finished installing this card in another NT workstation and got the same results. Could it be that the SCSI card or cable is bad?

by phil

If you press CTRL "A" on bootup ( when the card is detected ) you will see two menu items, Select host adapter settings, In there you will find an entry for allowing the bios to load,

I don't think that this will solve your problem with the CD burner but it will allow the BIOS to load,( you never know, stranger things have happened )

Let me know if it works

by roberwel

Hit CTRL+A when the scsi banner comes up. Somewhee in the bios of the card should be an option to disable LUN support. The scsi BIOS only loads when it detects a bootable device connected to the card (i.e. a bootable hard drive) Also, check termination, if the drive does termination ,disable it by removing the jumper on the back and use a terminated cable. Usually when the card and the OS see the drive it is either termination or a problem with the drive.

by csmith

The SCSI BIOS not installed message is normal if no hard drive is installed.
The BIOS is only used for HDs and INT 13.
It is not important. You can disable it (if it bothers someone) in Advanced Configuration by selecting Disable BIOS.
Try the SCSI card and the 6020 in a Win98 machine. I have never seen a properly working driver for a 6020 in NT.
Regards, Chris

This discussion is closed to new replies.