Discussion Locked

Secondary IDE CD-Rom

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a problem with my cd rom. I have recently installed a second Harddrive so i had to move the cd rom to the second ide channel. However in windows the cd rom is not present, but when i boot the machine it detects the a cd rom. When i go into Device Manager and go to Hard Drive Controllers. There is and ! mark next to the second ide channel. What do i have to do to fix the problem. If it is a driver i need where can i get it from.
Please Help THanx

13 replies

by dmiles

Open the CMOS control panel to the bios and under peripheral configuration,check to see if you have secondary fifo controller enabled.
Also check the Device Manager and check the hard disk controllers and see if single fifo or dual fifo is listed,if dual is not listed then you need to enable it,as stated above.
also make sure you have the jumpers set on the hard drives and cd-rom as master or slave depending on your setup.

by danpiers

Use REGEDIT (Start menu, go to RUN, and type REGEDIT. Click OK.) Select Edit from the menu and then select FIND. Type "noide" (don't use the quotation marks) in the FIND WHAT box. When you find this entry, delete it. (While the entry is highlighted, press the DEL key on the keyboard, then press ENTER.) Close the REGEDIT program, then reboot your system and your CD-ROM should be found. Good luck.

by fenaikh

Hi
THere is more than one reason that you get the yellow ? .

1- Scan for viruses.

2- Delet the NoIde.
Start ->RUN ->(Type) REGEDIT->enter key -> press Ctrl + F keys ->(Type) NoIde-> select it -(press ) Del key.

Good luck

Mohamed

by deric_ykb1

for your problem having like this, make sure your jumper for the second harddisk and cdrom drive must correct, when starting power on, make sure have detecting the harddisk and cdrom was appear in screen, if no appear, must checking either your jumper or bios there put to auto detect. if that is no problem, just in windows no detect cd-rom only, you goto delete the NoIde for below..

Start ->RUN ->Type 'REGEDIT'->enter for ok -> press Ctrl + F keys ->Type 'NoIde'-> select it when appear- press 'Del' key

after do this matter, reboot, if still cannot detecting, you must restart to MS-Dos prompt for installing CD-rom driver in the diskette. then reboot again for detecting..

by purple713

First of all, when you install a new Hard Drive and move things in a system, the first thing you need to change is the jumper on the back of the drive. Always look at the jumpers. Once that is done boot the machine to see if the CD-ROM is detectedif it is not then look at the CMOS setting and make sure it the drive is set to Auto Detect.Hope this helps.

by cascom

Whew!!!
Lot of very good answers, maybe too technical...
Check cables first, replace the cable connecting the CDRom drive to the controller with a new (or known good) one. Make sure the trace is at pin 1 both ends and make sure the cable ic correctly connected both ends. Provided the controller is enabled in BIOS and there are no controller faults on the motherboard it should work.

This discussion is closed to new replies.