Discussion Locked

Serial - Parallel Port Not Detected

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have Intel PCIset SB82371FB chipset with Pentium-S 75 Mhz processor & Award Modular V4.50G BIOS. No any serial or parrallel port detect on motherboard. It shows Serial Port : None, Parallel Port : None. Also no any Floppy Drive works on it. HDD detection is OK. Windows 95 runs without Mouse. I have tried by changing Serial & Parallel port in BIOS with every possibility.

Can anybody have information about it?

8 replies

by nsceml

You may have done more harm than good in your bios setup. All you needed to do was to make sure they were turned on. To install serial and printer ports just go to control panel/install new hardware/choose(ports) and then the ports you need then allow your machine to install them. You will be prompted for your W95 CD. Then reboot and
you should have them.

by csmith

Do I understand your question?
You are saying that the POST screen shows no serial port, no parallel port, and the floppy does not work. (It makes no difference whether they are enabled in the BIOS or not enabled.)
The last time I encountered thisproblem the chipset was bad on the motherboard.
I put in a serial/parallel combo card, but the floppy controller card could never work because the motherboard chip had shorted IRQ 6.
Sorry about the bad news.
Regards, Chris

by csmith

To cdobbin,
Sorry, you misread the answer. When the I/O chip fails, the serial port and parallel port can be enabled in the BIOS and they will not work. When they are disabled in the BIOS they are not supposed to work.
Shorted IRQs occur when a "bridge" develops, due to a defect or problem, and the IRQ line becomes so "loaded" that the 8259 Programmable Interrupt Controller on the motherboard can not sense the transition that signals an interrupt.
This is a very rare problem, as you have observed.
Hopefully, just the I/O chip is gone.
Regards, Chris

by cdobbin

This is not so much an answer but a question on answer #2. What do you mean it does'nt matter if the ports are disabled in bios, of course it matters, and what on earth do you mean it shorted IRQ 6???? In all my years of IT never once heard of a "shorted IRQ"

This discussion is closed to new replies.