Discussion Locked

Setting H.D. to master

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I want to set my new H.D. to master so that I can slave the old one and take data off this old drive. This old drive has bad sectors. Question, the new drive (40GB 7200 rpm Winchester) will only work with pin setting CABLE, when I try to use MASTER pin setting, the system will not detect it. BIOS is set to auto. Any suggestions what to check/change

7 replies

by james goerke

Ive seen this before. What I ended up doing is setting the master one to Cable and then putting the second HD one IDE 2 as Cable or Master. That should work. If this is a really old system like a Pentium 2 or below then I would suggest looking for any possible BIOS updates to accomodate the larger size HD's.

James Goerke

by jsarinana

Thanks, It's a AMD 700 so it's not to old. I would guess some systems just don't like some of there h.d. brands mixed.

by fred07

The master must be on far end of cable. On new 80 line cables; Blue to MB, Black [other end] to master and Gray [middle] to slave. this is for cable select jumpers or no jumpers. Also did you set your old HD jumpers to slave. Proper positioning on the cable is important.

by csmith

The sure way to get around drive incompatabilities, etc.
Put the new drive on the first IDE channel. Cable is fine.
Put the old drive on the second IDE channel.
Then it does not make any difference what the settings are.
(Temporarily remove theCDROM from the second IDE channel if necessary.)
Transfer the data.
An Advantage: the two channel method will give a faster tranfer.
Regards, Chris

This discussion is closed to new replies.