Discussion Locked

Setting up wireless network

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have two computers networked with ethernet, running into a hub with the cable modem. I want to replace the hub with a router to share the cable modem and add one or two more computers with wireless connections. What would be the best route to achieve the best speed and lowest cost? An ethernet router with an access point for the two new wireless machines? Or a wireless router that the two new wireless machines could talk to right off? The only reason I see to use the ethernet router is to keep a 100Mbps speed between the two ethernet connected machines. What would you recommend as a good setup while keeping cost reasonable? Also, will the speed of the internet connection lower if I have more machines feeding off of one ip? Thanks.

6 replies

by djent

You will get better performance all around if you use CAT5 network and a router to your cable. Wireless is as secure as citizen band radio at this point and lacks the performance CAT5 has.

by vinnyd

The best speed and lowerest cost is still a wired network.

The 100-base-t cabling gives you the fastest speed between computers and the hub and does not expose you network to the outside as when using a wireless network. Wireless networks do havenew options to prevent outside users from acccessing the network, but most people do not understand that how to set it up or do not know where to find the options in the routers.

A router with 4 ports would be the way I would go.

The internet speed question: well there is only one connection to the internet! That connection can only run at 10-base-t speed (10 mps).

Having 2 or more computers accessing the internet at the same time does slow down the connection on each computer. With a Cable modem, you are not likely to see the differance in speed. If you were using a ADSL at the lower speeds you would.

by jeremy

I was informed that wireless routers have a 4 port connection for your ethernet wired computers to run into? I was also informed that the speed of these ports is the max that the nic will allow (100Mbps) and not the 11Mbps speed of the wireless nics. If this is the case the only drawback i would see is the security issue, and how close would someone have to be to tap in and how would they even know I have wireless? Let me know. Thanks.

This discussion is closed to new replies.