Discussion Locked

Sharing a DSL connection on a network

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a DSL connection hooked up to a WIN NT SERVER. HOW CAN I SHARE THIS CONNECTION WITH 5 OTHER PC'S? I HEARD I NEED A DSL ROUTER. IF THAT IS TRUE DO I NEED TO USE A CROSSOVER CABLE GOING FROM THE DSL MODEM TO THE ROUTER OR CAN I USE REGULAR PATCH CABLE?
HOW CAN I MAKE ALL THIS WORK??

THANKS FOR YOUR HELP

11 replies

by ebob

1 - There is no ONE RIGHT answer (it's a lot like real life).

2 - Here's how I have done it:
- DSL Router (which also acts as a switch/firewall/DHCP server/print server)
- If it has not enough ports, get an expansion switch/hub and let the vendor advise on the cable to connect the two
- straight cables from ALL PCs to switch ports
- peer-to-peer networking on the LAN using TCP/IP only (no IPX, no NetBEUI)
(ah bliss)

3 - OK, or you can setup your NT box as a gateway on a hub/switch and route your other systems through it (via a hub/switch), etc.

TIP: STANDARD NETIQUETTE SUGGESTS THAT all caps IS TO BE CONSIDERED SHOUTING!!!

by qb4006

How is your DSL modem connected to your DSL router. Straight cable or cross over

by kschang

How are your existing computers connected together right now? Do you have a hub? If so, just use one of the hub ports to connect to the DSL router. Crossover cable is ONLY used in situations where there is NO HUB.

--KC

by vertex

My Aztech DSL modem needs a crossover cable to my SMC Barricade Router. However I can use the normal cable if the DSL modem is connected to my Compex NetPassage by using the uplink port, all I have to do is activate a tiny switch. Least to say, different hardware will have a somewhat different requirement. Check your documentation for the right answer.

by chris hirst

Not an answer but a comment to answer 4.
That is because the Uplink port on most Hubs\Switches can be either straight through or cross-over. Usually selectable by a little switch

This discussion is closed to new replies.