Discussion Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm looking into trying a SLot 1 to FCPGA coverter to increase my processor upgradability to accept a faster processor. Does this work very well? Are there any considerations as to motherboard compatibility? I have a PIII 550 with a 100mhz bus. Andwold like to upgrade to a PIII 1 ghz. Would that work?
7 replies
by dmiles
Will the mother board support this upgrade,most likely not
1)P3 is based on a 133mhz bus
2)You will need to upgrade the memory too
No short cuts this way,you would be better off building a new machine
by andycook
Poster rated this answer
You need to buy a SLOCKET, this will allow you to use faster P3 processors. But as soulrider pointed out, Newer P3's use A 133Mhz bus, you will only be able to use up to A P3 800Mhz, as these were the Last P3's to use the 100Mhz bus.
OK.
Matthew Shine.
Computacenter, Europe.
by andycook
Poster rated this answer
Also, find out if your motherboard supports a 133Mhz FSB, if it does, you can use P3's beyond 800Mhz as long as your motherboard supports it AND you buy PC133 memory to go with it.
by andycook
Poster rated this answer
by andycook
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies