Discussion Locked

Slow Network

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Three months ago because of downsizing I had to combine two offices into one. Each office had its own server NT4.0 and 3 or 4 hubs. Combined I now have 2 servers 7 hubs and a nearly full class C ip address range, I have 1 ip remaining. The servers are compaq proliant 800 400mhz with 196mb ram. They are only file servers. The problem is now that I am getting alot of complaints that the network is slow. I am thinking of adding more ram to the servers and installing switches instead of the hubs. Is there anything else I can do to increase performance. Would putting another nic in the servers help.

6 replies

by jimbb

7 Hubs? How are they interconnected? Are you aware of the 5-4-3 rule? And what ethernet speed? 100 Mb doesn't allow the same distances than 1o Mb does, maybe you've "crossed the line".

In any case I would split up this network, either with acentral switch, or with some routers. In both case you would create (at least) 2 smaller collision domains, limiting rubbish being sent out by a faulty NIC or broadcasts or so to that one "domain", and you would prevent too long distances in a collision domain.

Jim

by tcgraser

Stackable hubs, 3 in one closet lower level 4 in closet on upper level. Max distance from any workstation to patch panel is < 125 feet 90 % are < 80 feet. How do you create 2 smaller collision domains with 1 class C subnet ip network address range (ie. ip's x.x.x.128 - x.x.x.191 mask 255.255.255.192) not an entire class C range.

by some guy in seattle

To add to this, 10Mb and 100Mb are fine at 100 meters or less, per the standards. This sounds like a problem of network saturation. If you have utilization indicators on your hubs, check out what they indicate. Acceptable use on ethernet is considered to be 20% or less. If you can set it up at 100MB, so much the better.

Your best bet is to get a switch with enough ports to have a dedicated port for each of your servers plus a port each for your hubs. Try to keep hub stacking down if possible (keep one hub per switch port).

You're also a little confused as to "collision domain" and "subnet". A collision domain is a shared network segment that has no traffic management device (router or switch). Typically, these are hubs and repeaters. A switch will build a list of MAC addresses and only passes traffic across the ports necessary, instead of broadcasting them on all port (like a hub does). Becasue switches are layer 2 devices, they have no concept of anything other than MAC addresses, consequently an IP subnet makes no difference to it.

Hope that helps -

This discussion is closed to new replies.