Discussion Locked

Slow Network

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We run 2 Nt 4.0 update 6 P3 800 mghz with 512 meg ram servers. They have Intel 10/100 nics running full duplex,. They run through a 2 Linksys 10/100 auto switchs and 1 10BaseT hub. We have 50 users running Windows 98 All are static TCIP. with a varity of configurations. A lot of times it can take 5-10 minutes to transfer a 20 meg file. Other times it will only take 30 secs. Small files (less than 2megs)will transfer real fast almost all the time. It doesn't appear to matter which computer it isor how many people are on the network. At night when there is only 1 or 2 people it will act the same.It seems to be worst on the systems that are connected to the switch. I tried another switch to no avail.
Does anyone have any suggestions on how to help. 1 person told me that having the hub hooked up could be hurting the whole system and that i should switch to half duplex unless I remove the hub. (all hubs run at half duplex) Any help would be appreaciated

7 replies

by trurod70

Put your server nic card to 10mb half duplex. You should set your switch to match your server nic card.

by jyimcse

first, take the hub out. You network is as fast as the slowest component. Your symptons says that periodically, your have alot of traffic on your network. Reduce traffic. If you can, get rid of any protocols you do not need such as netbeui. If you have network printers, diable DLC and Ethertalk.

by estebandelatorre

It all depens on how the hardware is interconnected.
1.- Consider an uplink cable to connect the two switches. If not possible, consider a trunk between the two switches.
2.- Match your most intensive users with the best harware, the best nic and the switch near to your server.
3.- Put one server to switch 1 and the other to switch 2. (both at 100mpbs full duplex)
4.- Connect all 10mpbs nics to the hub, and the hub to the most accessed switch (or server) using a cross cable. Set this switchport to 10mbps half duplex.
5.- If still not get a continuous performance
you must disable switch auto-negotiation speed, and set them to match the nic attached. This is one of the most common slow down issues. Some people recommends setting 100 mpbs nic cards to half duplex, my experience is not. 10MBPS should allways set to half (full duplex under 10mbps is an "injerto")

This discussion is closed to new replies.