Discussion Locked

s.m.a.r.t failure

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have harddisk that can't be use because of the problem detect by diagnose tool mentioned the smart is failure.

What should I do to this harddisk?
- Can this hard disk repair?
- if can what software is the best solution/suggestion to do so?
- Can the smart delete from harddsik?

Thank you.

7 replies

by dcosgrove

SMART is a relatively new feature. Many hard drive BIOS combinations will not work properly together. I agree with the first answer. Disable SMART monitoring in the bios and see if your system seem reliable. Run a thorough scandisk to see if you have a deteriorating drive. Personally I don't trust SMART yet.

by mike.wagoner

You didn't mention if this was a new hard drive or an old one that suddenly started giving you this error message. If its new, then I agree with one of the other answers, go into your bios and disable it, that should take care of it - you might want to think about upgrading your motherboard bios while you're at it.

If its an old drive that has been working fine and you are suddenly getting this message - then bad news - you hard drive is on its way out. SMART technology is actually pretty good. Everytime I've come into a situation where SMART is giving us error messages, its a VERY short time later that the hard drive gives up the ghost for good (like 3 to 5 days). I hope for your sake its under warranty.

This discussion is closed to new replies.