8 replies
by djent
If you ever find the report etc let me know too. The only splitting of Cat5 cable that I have heard about is when you use the Cat5 cable to run multiple telephone or telephone and phone data links. Then it is usually restricted to two links per run.
technically I suppose that you could split the usage on the pairs but you would have to do that at BOTH ends of the cable run and have the other end INPUTTING two sets of data. Lots of risk of crosstalk etc, not worth it.
I very sincerely doubt that you can split the output from one end only except via a hub/switch or send the lot crazy with a 'y' cable.
by tchrist4
Poster rated this answer.
by paulp
I don't know if this will work reliably, but here's the scoop. Ethernet communications use pins 1 2 3 6 on a RJ45 connector. Pins 1 & 2 must be a pair - orange, according to standards and Pins 3 & 6 must be a pair - green, according to standards.
That would leave the brown pair and blue pair in a standard CAT5 patch cord available for your experiment. As you wire the pins, remember they must be straight through. That is to say PIN 1 to PIN 1 (blue/white), PIN 2 to PIN 2 (blue), PIN 3 to PIN 3 (brown/white), PIN 6 to PIN 6 (brown).
You will notice each color pair is twisted. The amount of twist in the pairs is important to reliable data communication. Do not un-twist more than a half inch to feed into the RJ45 connector.
Each of the 8 wires in a CAT5 cable is solid copper. Make sure you use RJ45 connectors that were made for solid copper wiring - as opposed to stranded copper wiring.
Pin numbering: hold the RJ45 connector with the opening for the cable towards yourself, and the little click-lock tab facing down - Pin 1 is on the left, Pin 8 is on the right.
I would love to know if this works for you.
by tchrist4
Poster rated this answer.
PaulP's answer is correct. I have done it as he describes & it worked with 2 ethernet RJ45's. However, it's not a good idea due to reliability issues & it MUST be clearly labeled on both ends. I would only use it in your home or as a lab connection within IT. Don't leave a mess for your successor.
I'm now attempting to get a similar configuration working in my home office, but instead I want 1 RJ45 4-wire & 2 RJ11 2-wires for voice lines. That's turned out to be a little harder. Has anyone done this before?
by tchrist4
Poster rated this answer.
by tchrist4
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending