Discussion Locked
0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I,m rebuilding my computer from a old system. I keep on getting an stop error. Please, check hard-drive or virus protection. After cheching hard-drive cable there is no power and the power switch isn't working.
1 reply
by ann777
Replace the power supply.
Depending on the form factor of your system (AT or ATX), you should have one or two leads from the power supply into your systemboard. Then verify that one of the power supply connectors connect to your hdd. Make sure the flat cable from the system board connects into the hdd as well. Then power up the system. Do not touch anything inside while the system is powered on.
If the fan on the power supply turns and you still get the same error, then look at trying another hdd, cable, etc.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies