3 replies
by oldefar
Try http://tinyurl.com/xrr0 for the International Engineering Consortium tutorials and references.
Sounds to me like a new name for an old approach. The Premise Distribution System consolidated horizontal runs to "closets" for cross connect to horizontal runs. Where the "closets" were placed was always a matter of choice provided distance limitations were observed, and the use of fiber for the vertical riser goes back to the early 1980's although it wasn't under any standards.
Network Cabling magazine http://tinyurl.com/xrtz covered a number of points in March of 2000.
Annexter always does a good job of explaining their products. See http://tinyurl.com/xru8
by csmith
Homerun is a term out of telephone wiring not networking.
The practice of having a "wiring closet" in each section, and a "Riser" as the "Trunk" or "Backbone" (depending on configuration, etc. ) is done, not to assist in upgrades; it is done to insure proper network response and reliability.
A "home run system", as you would use in a telephone installation, would be a nightmare.
The excessive collision problem would be an almost continuous occurance. Isolating problems would be more difficult, and the excessive cable runs would be out of bounds.
That is just for starters.
Even small companies do not use "home run" anymore.
The last one I saw was over ten years ago.
Everybody uses segmented networks with backbone.
There may be some people using new vocabulary as a fad, but network design is pretty stable, and a commodity item.
(That's probably why the hype.)
Regards, Chris
by wlbowers
We have been doing this since the 60's. It is simple economics.
16 offices on a floor times 200' to the computer room is more expensive than a 16 port hub and one home run.
Lee
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending