Discussion Locked

stuck at boot, no green MoBo lights, help?

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

First of all I'm new at this. I'm building my own computer with the help of my roommate who has pretty good computer hardware knowledge, but we dont know how to quite figure out what is going on.
Basically I hooked everything up (seemingly correctly) including MoBo, CPU, heatsink, power supply, video card, HD, floppy, DVR and put in all the cables and jumpers as the manual said were best for all I was doing, etc..
when I turned on the power supply with everything connected the red lights on the motherboard were showing, and when I turned on the computer the fans started and then stopped. So I disconnected the power on the HD, floppy, etc, and tried it then. still have the red lights, not green, but this time the fans keep going. Nothing comes on my monitor though, and the post symbols read "FF", which the manual says means "BOOT" - so I guess thats where its stuck?
what im building with:
-Biostar TForce590SLI Deluxe AM2 (mobo, it was open box)
-AMD/A64 6000 3.0G AM2 2X1M R (cpu)
-Thermaltake TR2 550W ATX 12V 2.0(power supply)
-VGA EVGA 7900GS KO 256-P2-N624-AR R (video card)
-Hitachi 250 HD 7K 8M SATA2 0A316363 (hard drive)
-the DVR was never plugged in because i need to get another SATA cable

anyone have any advice? thanks.
-Chris

6 replies

by mjd420nova

If the fans try to run but stop, something is shorting the power, or the power supply is weak. Isolating the HD didn't let it boot so you've got a short. Did you notice any insulating washers on the underside of the motherboard?? if needed and missing, it shorts out the power.

by hey_over_here

thanks for the reply. Earlier today I unhooked my power supply from the new setup, and connected it to be existing computer after detaching the old Dynapower 300W Max that its usually hooked to. With the new power supply my existing computer worked fine, didnt spin the fan superfast, but my old computer acted just a little more smoothly.
no change on the new machine tho. red lights still, "FF", and all fans going at a good power.
I'm really starting to think its this motherboard, I shouldnt have gone with open box, heh.
and on the washers, I have raised parts of the case that keep the MoBo from sitting on the metal. screws are placed into those holes/raised portions after the motherboard is set down. isnt that right?
the mobo only came with a couple of risers anyways.
-Chris

by 1bn0

Remove the motherboard completely from the case.

Place it on your work surface. If the board came with an antistatic foam, place it under the board. Otherwise make sure the board is not on an electrically conductive surface.

Make sure the CPU is correctly inserted and attach an appropriate CPU FAN.

Insert 1 piece of memory.

If the board has an on board video chip, use it for your initial tests. You can change to an add in video card later. also , if using an on-board video chip, make sure thememory is in the first slot. On board video often uses system ram to run the video chip, but only from the first memeory chip.

Connect the power supply.

Connect a power on switch to the appropriate contacts.

Connect the monitor, and if you want to a mouse and keyboard.

Power on the system. You should at least get the initial BIOS boot screens.

Do NOT add anything else until you get the system to boot to the bios screens.

If the system boots. Install it in the case WITHOUT any other components and make sure it will still boot.

If it does not boot then you probably need to isolate every mounting screw. I have had systems where it was necesary to put washers on BOTH SIDES of the mounting holes.

If the system still boots add components one at a time. ITs a little time comsuming but often easier than assembling everything and then having to remove it all and start over again.

by hey_over_here

I decided to return it, buy a New, unopened board after spending all nite and all day doing different things to try to make it work. I just got through taking a nap after repackaging it. I can get my refund, pay 30$ more, and feel a little more at ease during setup. There were never any changes and I never saw BIOS or anything, so I'll just cut time-losses and go with something that'll be more of a secure buy in the beginning. and this time I'll check it first outside of the case before installing everything, thanks.

-Chris

by hey_over_here

I appreciate some of the quick replies and attempts at helping. I'll know where to go next time to fish around or ask for answers on certain things.
Turns out it was the Motherboard that I had, so I lucked out by returning that piece. I got a NEW Biostar, NOT open box this time, and am now writing you all on my new kickass computer. man, it was completely worth it to pay 30$ more for a WORKING mobo, tons of extra cables, a mic/headset and connectors. beautiful. anyone ever played Thief III: Deadly Shadows? great game. Im gonna play this and F.E.A.R. when I can, then get some gr8 new games as well, see how music-recording goes, etc.
take care!
-Chris

by deepsand

Try the "Questions" forum; the "Discussion" forum is for matters of general discussion, not specific problems in search of a solution.

Post problems such as this to the "Question" forum, rather than the "Discussion" forum. There are those who specifically seek out problems in need of a solution, and that's where they go to look for such.

Additionally there are the benefits that:

1) The "Questions" forum provides for your feedback, by way of your being able to mark "helpful" responses as such. This does not necessarily mean that a given response contained the complete solution to your problem, but only that it served to guide you toward it. This is intended to serve as an aid to those who may in the future have a problem similar to yours, so that they might have a ready source of reference available, thereby perhaps obviating the need for them to repeat questions previously asked and answered.

2) The revised TR makes it quite difficult to find both "Discussions" and "Questions" that have not had a fairly recent post, owing to some functions comingling them in the listings. By keeping each type in their respective forums, it is easier for all to find what they are looking for.

This discussion is closed to new replies.