Discussion Locked
0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I've recently had a system shut down on me shortly before booting.It has a chaintech board with K-6 Processor at about 500 mhz. I've noticed that the PS was smoked(suspected lightning but not sure)replaced it with a good known used one only to smoke it too. I disconnected all cards,& unplugged all drives with no success.I purchased new bigger PS only to find out fan turns but shuts down in couple of seconds. I suspect that the board shorted but don't trust my troubleshooting to confirm this. Can anyone suggest a method to avoid changing unnecessary parts. (it also wasted cd burner and the HD).
1 reply
by thechas
Start by looking the motherboard over carefully.
When a motherboard goes this bad, there are usually signs of the problem.
Start with the large transistors and capacitors near the CPU.
You are looking for scorch marks, or bulged parts.
Next, you can use a multi-meter to check for shorts.
With the power supply disconnected, connect 1 lead to a ground pin, and check the resistance to all the other pins. Then reverse the leads.
I would be suspicious if any reading is less than 100 ohms.
If you do find a short, remove the motherboard from the case, and see if the short goes away.
It could be as simple as a power point connecting to chassis ground.
Chas
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies