8 replies
It sounds to me like some kind of tamper-proofing hardware was installed and then partially removed. Try resetting the CMOS after checking what cards are in the slots.
Ralph
by ppatterson
by csmith
I assume you bought this PC at a surplus auction, or it was transfered into your department minus tech support. (That was polite)
I say this because if it runs Win95 it must be old/obsolete.
Can you open the case?
If so, look for a small ISA card.
Remove it.
Look for BIOS (CMOS) battery.
Remove battery for at least one hour, or remove "CMOS jumper". (Some MBs have a backup capacitor)
Reinstall.
Do you have important files on the hard disk?
I assume no.
Boot on floppy, wipe hard drive,setup new partition, format, and install Win98SE
Regards, Chris
by ppatterson
by csmith
Your Reply does not jibe.
There is no reason that you would not have the security code, if this was a simple replacement.
This sounds like data theft, to me.
Who bribed you to steal this information?
If this is another incident of this problem, my advice to you: do not get involved, etc.,etc.
Bye.
Chris
by ppatterson
by csmith
Hi Patsy,
Got the OK from your boss, Friday afternoon, that your request is legal.
Will email you personally.
I am not allowed to post correct methods to bypass asset control, for IBM PCs, on a public forum.
Regards, Chris
by ppatterson
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending