Discussion Locked

tekram SCSI

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i'm using promise fasttrak66 RAID 0 and tekram 390U SCSI card. after install win2k adv. server. the RAID is working fine; but my SCSI card keep show as "disable". i try upgrade the SCSI driver but end up it freeze at startup. as far as i know, RAID is alway sees as SCSI device.
my question is 1) is it possible to using 2 different SCSI in win2k server??
2) bios is loadup correctly for both card. what's other possible problem it can be??

here is my detail config

AMD 350
FIC mortherboad(IDE disable) w/1mb
256 pc100 RAM
2 ultra66 60GB HD in RAID 0
tekram 390U SCSI wide controller
HP SCSI CDR
sony SCSI CDROM
ATI 4mb vcard
intel 100BT NIC

2GB FAT in C: (win2k system/boot)
1GB NTFS in S: (swap file partition)
12GB NTFS inD: (application parition)
100GB NTFS in U: (Data)
E: and F: is CD-ROM/R

1 reply

by operatorx

1. try removing the scsi card from the device mgr (you did say adv server 2000?)then reboot and try installing correct drivers from that point.2.make sure all id's for scsi are correct.3. i know on the 2k server install, right at the beginning of the install it ask you to press f6 to search for scsi devices (or something like that) so if there is nothing on the computer try reinstalling.4. make sure the scsi chain is terminated if applicable.

This discussion is closed to new replies.