Discussion Locked

TOP-GLORY CDROM P\N BCD E520C

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I HAVE A TOP-GLO CDROM 40X. I ALSO HAVE THE INSTALLATION DISK AND IT INSTALLS UNDER DOS. I CAN'T GET INSTALLED EVEN WITH PRAYERS.I DONT KNOW IF IT WORKS WITH WIN98 OR ANY PROGRAM. PLS SEND A TIP. THNKS

11 replies

by still_learning

You do not specify what errors/problems you are having. You may want to download the Win98 device driver for the drive and then try installing. Good luck.

by still_learning

You do not specify what errors/problems you are having. You may want to download the current device driver for the drive and then try installing. Good luck.

by still_learning

You do not specify what errors/problems you are having. You may want to download the current device driver for the drive and then try installing. Good luck.

by thechas

You only need to use the installation floppy if you want to access the drive from DOS mode.

Check that the IDE cable is connected properly, and that the Master Slave jumper is set correctly on the Top-Glo, and any other drive on the same IDE cable.

Then you need to check your BIOS settings.
Press the appropriate key to enter setup while the system is booting.
Then, find the hard drive / IDE settings section.
Make sure that the IDE channel (primary, secondary) is enabled, and that the drive setting (master, slave) is set to either Auto or CD-Rom.
Press the appropriate key to exit and save settings.

Windows should now find the CD drive when you boot up.

If your still having problems, right click on the My Computer Icon, and click on Settings.
Click on the device manager tab,
Expand the CD drives branch, and see if your drive is listed.
If another drive is listed that is not presently in your system, click on it, and click remove.
If your drive is listed, but has a "?" or "!" mark by it, Windows is having trouble with the drive.
It could be that the drive is dead, or that there is a conflict with how you have it set up.

2 things that you can do at this point,
1. Try removing the DOS driver. The simplest way to do this is to go to start/run, and type in and run msconfig.
From the startup tab, uncheck the dos driver for the cdrom drive.
Click apply, and follow through the sequence to reboot and check things out.
2. You need to install the IDE buss driver for your MB.
Either go to the MB mfgs. web site, or the chipset mfgs. web site, and download the latests drivers for your MB/chipset.
If you need help finding the web site, go to www.driverguide.com
If you need help identifying your MB/chipset, go to www.motherboards.org

by csmith

We have four of these installed.
They are compliant enough that the standard OAK.SYS driver of Win98 recognizes them without any driver.
Try commenting out the drivers in CONFIG.SYS , and AUTOEXEC.BAT
Then it should work with no driver.
(This CDROM is installed on the second IDE channel as slave? All ours are.)
Regards, Chris

This discussion is closed to new replies.