Discussion Locked

TOSHIBA DVD/CD-ROM Problem

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a problem with my DVD/CD-ROM Drive, which is TOSHIBA DVD-ROM SD-R2002 Drive.
I use a TOSHIBA SATELLITE PRO 4600 Notebook. The operating system is WINXP PRO.
When I start the computer with the drive door closed, there is a twofold knocking noise in the drive and the drive can't read or write. By accident I discovered that when I leave the drive door open, before shutting down the computer, and then restart the computer with the drive open, I can use the drive for reading and writing CD ROMs. So I use the drive in this way. However I am interested to find out what is wrong with the drive that it can't operate after starting the computer with the drive door closed.

Note: before discovering this curious behaviour I asked the question reporting the problem of double knocking noise at starting the computer and the inability of the drive to read or write. I was advised that the laser tracking mechanism was out of order and that I change the drive. However, as described above, I discovered later accidentally that I still can use the drive if I leave its door open at starting the computer.

What can be the problem and its solution?

An answer will be very much appreciated.

Frank Woda

1 reply

by thechas

Okay, the drive can / will read and track properly.

I suspect a problem with one of the switches / sensors that let the drive controller know where specific items are.

It could be that the end of travel switch for the laser is bad.

Or perhaps the disk detection sensor is bad.

One more thing that you could try is to boot up with a CD in the drive and the tray closed.

If it also works if you boot with a CD in the drive, then I suspect a problem with either the disk detection or the drive end of travel sensors / switches.

It could be as simple as the laser sees a reflection when powered up at boot and the drive controller sends the laser to look for the file table.

When that operation fails, the drive controller sets a fail flag and refuses to operate for the rest of the session.

Chas

This discussion is closed to new replies.