Discussion Locked

Toshiba Tecra 8100 & W2000 Networking

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am using Windows 2000 on a Toshiba Tecra 8100. I am trying to setup networking in order to connect to a PDC. I'm using a 3com 10 Mbps LAN Card. Windows 2000 detects and installs it fine, however I can't ping anything or connect to any domain. Windows 2000 seems to think the network cable is disconnected. I have downloaded a hotfix from microsoft as there are issues with the PC card contoller on this laptop, but still no joy. I would apprecaite any ideas on this one, so would my Tecra as it does not feel like a trip out of the window today. Thanks

4 replies

by doug w. mcse nt/2000

Make sure you load all the Win2000 drivers from Toshiba's site. My 8100 didn't work completely until I did....even then, they didn't have the DVD patch/driver at the time. It all worked fine after that.

Also, check the basics. Is your cable good?Test it on another machine. See if the connect lights are lit. Make sure you aren't using a crossover cable, etc..

Good Luck!

by rob mackay

The physical networking side is fine, as I run NT4.0 and get connections no problem. The laptop also has all W2000 drivers installed.

by shanghai sam

Rob did u try to install that network card on another machine and checked with it? try it also 'caue some cards detect and install drivers perfectly but won't transfer data we've found few network cards like that way.
thank you and hope it work smoothly.

by maxwell edison

Greetings,

If your NICs are 3Com 3C905b-TX (or TXNM), make sure you're using driver version 4.01. I've discovered that the drivers provided with the newer cards (driver versions 5.0 & 5.01) are problematic.

Maxwell

This discussion is closed to new replies.