11 replies
by thechas
With some caveots, yes.
Always place the PC so that the motherboard is at the bottom.
Looking at the front of the PC, that would mean the right side down.
Make sure that the hard drives are either on their sides, or right side up.
While mosthard drives can run upside down, it places more stress on the platter bearings if you run the drive upside down.
You will not be able to use a 'standard' CD-ROM drive.
If you are looking to leave the PC this way permanently, why not just buy adesktop style case, and move the parts into it?
That way, you won't need a special CD drive.
Chas
by jrnayadley
by parvus1202
by jrnayadley
by guruofdos
Agree with The Chas...other points
CD drives faster than 16x should NOT be run on their side. Older drives often had moveable clips in the tray to allow the drive to be operated 90 degrees out, so to speak. Alignment of the CD was maintained by these clips so as to ensure the disk went in correctly alaigned. Modern drives don't!! At 48x spin speed, a badly aligned disk will probably shatter.
Towers normally have holes towards the bottom of the tower for ventilation so that airflow moves from the front bottom to the top rear or the case. This is affected by moving the tower 90 degrees. You lose natural convection and have to rely on forced cooling. In many PC's, cooling is barely adequate as it is, so any compromise in cooling is a 'bad thing'.
A decent ATX desktop case can be had for less than ?20 (US $30) so why take the risk?!!
by jrnayadley
by opatzg9
Yes, but as stated above the rest of your pc isn't built for it. The main thing with your hard drives to consider is how were they formatted, it is best to format them in the position they will be running in as well. Best bet is buy a desktop case, but destops dont always have the bay space you'll wnat for add-ons.
good luck with whichever you decide.
by jrnayadley
by yelhsa3840
by jrnayadley
by jrnayadley
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending