Discussion Locked

Trouble with HyperTerminal on Cisco 1720

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a client who used to have a T-1 line into their office. He took it out and now uses DSL. (only 5 users) But he had a Cisco 1720 collecting dust and asked if I wanted it. Of course I said yes so I could practice and play with it. But when I connect using Hyper Terminal, it says I'm connected but when I hit enter I can't get to the prompt. I'm using a management cable (serial DB 9 on one end and RJ-45 on the other) from a Cisco 678. I'm going 9600 baud, 8 data bits, no parity, 1 stop bitand no flow control. The two lights that are on are solid green for power and solid green for OK. Any help will be appreciated!

5 replies

by dcosgrove

First of all, I would use teraterm pro, you can get it free at download.com. Then I would need a litlle more info. Are you going into the "aux" port on the router? I'm not real familiar with the 1720, but I usually use a mod tap (serial 9 pin to rj45) with part number74-0495-01 and a full rolled cable to the aux port on the router. Make sure the com port is set right in hyperterm or whatever you use and try to boot the router with it connected. Your settings are correct though, 9600,8,noneand 1. Other than that It's tough with out seeing what you have.

by wlbowers

Make sure the cable is in the right port. The
console port.
I use procomm plus. Settings are as follows:
VT100 9600 n-8-1. When you have everything
ready, Cycle power on the 1720. You will see
the text scroll as the unit comes up. If you don't
see the text scroll you ain't got something
right.

More information on this is avaible on cicso's
website.

Good Luck Lee

This discussion is closed to new replies.