Discussion Locked

Trouble with newly installed switch

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently tried to upgrade a small 7 user network to a 10/100 switch from a 10 hub. When all was started up again the machine with 10/100 cards would not see one another, the machines with slower 10 cards would see one another just fine. One switchwas an SMC and the other a cheap no name. The cheap no name worked on my home network. Any info would be nice. Thank you.

5 replies

by stomlin

Try force the ports... On you computer, turn off Auto negotiate and set the card for a setting. Preferablly 100 Full Duplex. Then console (or Telnet) into the switch and set the port that the copmputer is plugged into to the same setting.
That iswhat I would try.
Scott

by grbeckmeyer

I would suggest trying to force your 10/100 NICs into 10MB mode. I think the problem is your cabling, and the 10MB Nics can handle the signal quality but it's just not up to handling 100MB. Buy a cat5 patch cable and try connecting one of the 10/100 systems directly to the switch, I bet that will work.

This discussion is closed to new replies.