Discussion Locked

Troubleshooting System Problem

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Ihave recently come in possesion of a Compaq Desk Pro 4000 system,when I try to boot up the system hangs at Post with error Keyboard or System Board error.

I have connected known good working keyboards to the system and still get the same problem,is their another way to diagnose the system before replacing the system board.

I have used boot disk to try and run diagnostics and this has failed because the system will not seek the floppy at startup.

I also cannot determine what key to press to enter setup

Thanks in advance for any suggesstions

13 replies

by captain krunch

Soulrider,

I don't know if it isn't reading keystrokes, but Compaq used at various times F1, F8 and F12.
Have you tried clearing CMOS, pulling the battery etc. I have seen this clear a similar problem.
Good luck!

by dmiles

Keys did not work when pressed,and the battery cannot be remvoed since it seems to be soldered in place to the retaining clip

by 1stladytech

You usually press the F10 key while the logo is on the screen, or when the cursor flips to the upper right corner of the screen and enlarges. This will get you into the cmos, but there is usually very limited setups in there.

Vickie

by d_v ant

It is F10 to enter the BIOS. It is possible that the BIOS setup was stored on a small partition on the hard drive. If that partition has been removed, you will need to download the SoftPaq from Compaq to enter it.
Try clearing the CMOS. There is ajumper on the system board that you move to pins 2 and 3. Leave it there for about a minute and then put it back on 1 and 2. If you still receive the error, then chances are that the system board is bad. There should be a diagram on the inside of the case showing the location o fthe jumper.
To be honest, if that is the case, you will be better off buying a new system.

by sgt_shultz

well, if you are inside the box, see if there is a connector labeled something like keylock switch and disconnect it...long shot but easy and painless to try...
don't suppose you have usb on that box to try usb keyboard?
can you force it to the floppy by disconnecting the hard drives? these folks must know compaqs better than me, i always thought you had to get to Setup on compaqs with the compaq diagnostic floppy disk, not from the keyboard...

by dmiles

Thanks for your help,you were on track that I needed a compaq diagnostic disk to getinto setup.The system board seems to have flown the coop

by thechas

Hi soulrider.

Have your tried a USB keyboard?

It's possible that the PS/2 port is blown.
Most likely from the previous owner hot unplugging the keyboard.

I would also try and boot with no mouse and see if that helps.

Chas

by dmiles

Thanks Chas,tried your suggestion and it would not work as stated the system board seems to have flown the coop

This discussion is closed to new replies.