Two Hard Drives.
I have connected my old hard drive to my new PC, IDE lead in, power supply in, but my PC does not even recognise it is there?
I have set the jumper on all three possibilities.
HELP.
Hardware
I have connected my old hard drive to my new PC, IDE lead in, power supply in, but my PC does not even recognise it is there?
I have set the jumper on all three possibilities.
HELP.
by cgi¤001
If one of your HD is a Seagate you might have the problem of incompatibility. Seagate gives nightmares in combination with some major other brands. Seagate with Seagate no problem. But Seagate with Maxtor or Western Digital or others: they dont dance together.
I know its an unpleasant answer, but its a fact... Sorry if it is your case.
by clothahump
by jlouis45
by clothahump
by fenaikh
Hi
1- Go to Bios setting and make sure that the setting of the 2nd IDE is enable and for all hard disk is set at AUTO.
2- TRy to Auto detect the hard disk which you have a problem with.
3- Save setting and reboot and see if your system display that it is been detected.
4- Disconnect all hard drive and CD-ROms and let only the hard disk you having a problem with make sure it set at master. and make sure that the red stribe at pin one in both side ide and hard disk.and if possible use theone is working with the other harddrive.
and make sure that the bins is afirm and fit in all the 2 side of cable and pins.(see if any proken pin in any side).Mkw sure electrcity is comming by using a working connection.
5-Set both hardisk in the master postion for both ide. (I faced some times that some hardisk the only work if they are master if the other is not the same type (WD).
6- I would make sure that THe hard disk is compatable with the IDE controler since the old type they depend oncontroler for formating.
Good luck
Mohamed
by fenaikh
more .. info
it could be also not enogh power comming to it you could move the montor to direct out let if you have it on the pc.
pls go and get good info and search for more.
Hard Disk Drive Connection Procedure
http://www.pcguide.com/proc/config/hdd-c.html
General Installation and Assembly Tips
http://www.pcguide.com/proc/gen.htm
Standard (40-Conductor) IDE/ATA Cables
by clothahump
by clothahump
This discussion is closed to new replies.
Sort by Trending