Discussion Locked

Two Processors on Server

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We installed two processors on our server that has a motherboard and processors that support dual processors. What do I need to do to get the computer to reconize both processors and how would I check that they are both reconized?

9 replies

by wim

First of all, sometimes adding a processor isn't enough, you could need a terminator for the 2nd processor (like compaq proliant 3000)
But it's possible that you don't need this.

To check the 2 processors, this should be somewere in your bios ordisplayed at startup.

with NT4 it's displayed at the blue boot screen and if you click the performance tab while logged in.

by djent

You need to reinstall NT. SMP uses a different kernal for multiple processors.

by saihib

Installing Support for Multiple CPUs
Click Start, point to Settings, point to Control Panel, and then click System.
Click the Hardware tab, and then click Device Manager.
Double-click to expand the Computer branch. Note the type of support that you currently have.
Double-click the computer type that is listed under the Computer branch, click the Drivers tab, click Update Driver, and then click Next.
Click Display a list of known drivers for this device, and then click Show all hardware of this device class.
Click the appropriate computer type (do not change from non-ACPI to ACPI computer types), click Next, and then click Finish.
The following table lists and describes each HAL.

HAL Description
---------------------------------------------------------------------------
ACPI MultiProc Use for a multiple-processor ACPI computer

ACPI UniProc Use for a ACPI multiple-processor board but with a
single processor installed
Advanced Use for a single processor motherboard with single
Configuration processor ACPI computer
Power Interface PC

Compaq Systempro Use for a Compaq Systempro computer

MPS Uniprocessor PC Use on non-ACPI computers dual processor motherboard
with a single processor installed

MPS Multiproc PC Non-ACPI computers with a dual processor running

Standard PC Any Standard PC, non-ACPI, or non-MPS. Could be a 386, 486, Pentium, Pentium II, or Pentium III

Standard PC
with C-Step i486

NOTE: You can use this procedure only to upgrade from a single-processor HAL to a multiple-processor HAL. If you use this procedure to change from a standard HAL to an ACPI HAL (for example, after a BIOS upgrade) or vice-versa, unexpected results may occur, including an inability to boot the computer.

This discussion is closed to new replies.