Discussion Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just acquired a Tyan S1692 MB with a case and full tower. The MB is dual capable and only has 1 PII in it right now. Before I got the board it had been used with a SCSI HD. The SCSI had been removed and kept by the previous owner. I want to use an IDE HD but I'm having difficulty getting the MB to recognize the HD. When I boot up I can hear the HD spin up and check itself but when I got to load Win98SE, I'm told that a HD cannot be detected. I've tried both IDE channels and have tried the HD in both master and slave setting but with no luck. Anyone familiar with this particular Tyan board and what can I do to get the HD recognized. Any help is as always very much appreciated.
7 replies
by donmars
It appears quite obviously that the last owner having had the machine configured for scsi in cmos setup left that setup as is. You need to go into setup, F2 or DEL whatever and tell it you are using an IDE drive! There is probably a setting for AUTOdetect in which case the cmos should detect your drive. Do not forget also to set the jumpers on your drive. The settings are usually printed on the drive and vary from drive to drive.
by hiland76
Checking CMOS was the first thing I did and set it to detect IDE drives. Probably should've mentioned that though.
by leo.valmores
Try to go into the MB BIOS setup and check if the IDE settings are right. Make certain that both channels are not disabled.
Another possibility is that there could be a jumper setting(s) to disable SCSI (if it is built-in to MB) Check further theMB manual if available.
Finally, check your IDE drive that it is set to Master (and not CS or SLAVE).
Good luck
by hiland76
Poster rated this answer
by donmars
What do you mean by when you boot up? One other obvious thing that you had probably done but did not mention, did you run FDISK and format the drive? You would need a boot disk for that.
by hiland76
Poster rated this answer
by hiland76
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies