Discussion Locked

UDMA100 HD into UDMA33 MB

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Will a 5400 HD UDMA 100 run on UDMA33 Motherboard?
I have an old Asus P2B-F MB and I was wondering if I can just plug in a newer HD like a WD 5400rpm ?

5 replies

by timwalsh

The simple answer is yes it should. Almost all new hard drives are backwards compatible with slower busses. Realize that drive access will not be as fast as it would be on a UDMA 100 bus.
If you haven't bought the drive yet, the box should tell you if it is backwards compatible.

by thechas

Yes, the drive controller will detect that the mb can only support UDMA 33.
You will be limited to the UDMA 33 transfer speed.

However, 2 things need to be concidered;
Does your OS support the drive size?
W98 can have problems at 32GB for somesystems.
You can work around this limit by partitioning the drive into 30GB or smaller drivers.
Most versions of W95 only support 2GB drives.
You would need to partition a 10GB drive int 5 drives to use the whole drive.

Does your MB support the large drive?

One way to get around a MB limit, and improve the data rate, would be to install an ATA100 IDE controller card.
If you look, you can get these for around $30.
Since you will be trippling the data rate, it will be the best speed improvement possible for $30.

This discussion is closed to new replies.