Discussion Locked

ultra 100/133

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
on the ultra 100 or 133 cable for a HDD, can two ultra 133's be on the same cable? i'm having trouble getting this to work. on is slave, the other is master. does the master have to be on the end of the cable or in the middle?

7 replies

by ptreadway

Your master and slave seting is on your HDD,on WD HDD Dual master is pins 5 and 6-Dual slave is 3 and 4.

Hope this helps

by cg it

Slave is in the middle, Master on the end [re: cable select]. I always put the slave [cable select or no] on the middle IDE connector and the Master on the end IDE connector.

by leehellcat

It should work fine with 2 Ultra 133's on the same cable. BUT Why do they need to be on the same cable ?

If they are both on the same cable, the PC will only communicate with one at a time. If they were on seperate channels the PC could access both at the same time, thus improving performance, which I am guessing is you main motive for wanting to use Ultra 133's in the first place.

The following link breifly describes a similar setup but using older equipment :

http://anandtech.com/showdoc.html?i=1237&p=2

If you want to run the 2 HDD's and a CDRom/DVD then you should invest in a PCI IDE controller, they cost about ?21.00 for a card with 2 IDE channels capapble of taking Ultra 133's.

This discussion is closed to new replies.