Discussion Locked
0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Okay, I have four Ultra 160 drives with that have 80 pin connectors. To connect to my SCSI card I have to use a 68-pin adapter. I have been told that this will slow my bandwidth to 80mb instead of 160. Is there any way around this? And is this true? thanks.
4 replies
by guruofdos
Yes to both your questions! Yes it will slow you down and yes there is a way round it!
Purchase a new controller!! Unless you have an Ultra160 controller, you cannot use the 160Mb/sec capability of the drives.
A 68 pin card will only give youSCSI-2 performance, i.e. 20Mb/sec bandwidth unless it's a FAST/WIDE controller in which case you will acheive 40/80 Mb/sec. The drives will work, but only at a fraction of their potential!
by techgirl75
Poster rated this answer
by techgirl75
Do you have any suggestions for a controller card that will support it.. I bought an Ultra160 card...but I have seen none that have 80pin on the card itself. Thanks!
by techgirl75
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies