Discussion Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I was given an ADAPTEC 2940 card. I would like to know if this is compatible with Ultra SCSI 160 harddrives. What size and type of SCSI harddrives it will work with. I have acculmulated just enough research to thoroughly confuse myself.
7 replies
by net_vamp
AHA-2940 is an Ultra SCSI card & should run with your hard drive.
However the only way to be certain is to go to your hard drive manufacturer site & take a look at the support pages for your hard drive model.
by s.m.wylie
Poster rated this answer
by hwold
The AHA-2940 is a SCSI fast (10MB/SEc), the AHA-2940U / AHA-2940AU are Ultra (20MB/SEC) cards. The setup will work with the proper cabling/adapters to connect the drive (assuming SCA80 or SCSI3 68Pin) connector to the cards 50pin connecter. I'd at least try to get a ultra wide card to get some performance out of the drive. Some good info can be found at http://www.scsifaq.org
by s.m.wylie
Poster rated this answer
by beeba
as far as "working" goes, it'll work, because drives will fall back. but a u160 drive will be wasted running with a standard 2940.
there are quite a few different 2940's out there. i personally have a 2940u2w which means it'll do ultra2, wide, orup to 80m/sec.
by s.m.wylie
Poster rated this answer
by s.m.wylie
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies