Discussion Locked

Unable to see drive

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have recently bought a flass usb drive. When I plugged it in Windows XP PRO detected it OK and installed the driver for it. It says it is OK under device manager and Computer Management tool see it OK, but My COmputer and Windows Explorer do not see the drive. I have Hard Drive letters asigned C,D,E F,G,H,I the CD/DVD drive is J the CD burner is K and L (Nero assigned the extra drive letter). So when I look at this flash USB drive with Device manager it says it is the M drive which all seems fine but as I said it does not show as a drive. If you can help me with this it would be greatly appreciated.
Regards Graeme

7 replies

by thechas

You have a problem, if 1 drive (the CD-RW) is assigned 2 drive letters.

I am not familier with Nero, and don't know why it assigned a second drive letter for the CD-RW drive.

The simplist thing to try, is to assign a higher drive letter to theUSB drive.

You can do this form the drive manager section of computer management in administrative tools.

I suggest that you look in device manager for conflicts on your CD drive.

Chas

by graemei

I tried changing the drive letter and if I ressigned one of the partitions to say P and then set this drive to H I could see it ok and use it but the partition I reassigned to P I could not see. The extra drive that Nero Burnibg rom assigns says that it is nero imagedrive scsi cdrom device I moved this to drive Z, This also can not be seen as a drive before or after I moved it.

by thechas

I have a new idea.

Does the USB flash drive need to be formated?

You may need to install a utility to format the flash drive.

Check the manual, and the drive mfgs web site for installation and setup procedures.

Chas

by graemei

The Flash drive does not need to be formatted. I can read and write to it on other computers without any problems.

by robp1

One thing you may need to do, is go into device manager - and make the drive "removable".
Most important - otherwise it will be recognised by Disk manager. Once it is flagged as a rem. drive, go into disk manager and assign a drive letter there.
Iassume the extra drive letter came from the Nero "Image Drive" utility - bit problematic under XP - Hope this helps
Rob

by graemei

The drive is marked as removable but still cannot be seen from Windows Explorer or My Computer.

by wlbowers

When I got my MIB pen drive it gave me fits till I called tech support.

Sometimes they get cranked. You should have gotten a utility disk. There will be a program that will sort it out.

Once I ran the utility on mine I have had no problems.
Good Luck Lee

This discussion is closed to new replies.