Question Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I had to perform restore from MS Backup and now my system doesn?t recognize my USB devices (external hard drive or thumb drives) and it won?t let me map a network drive (unable to see workgroups) to computers on my network. This all works fine on my other two computers attached to this home network. I cannot map back to this computer that I just restored to. I?ve uninstalled and disabled drivers and let windows xp pro repopulate without success. I did xp set up repair, installed sp2 & 3 and all updates without success. I upgraded mother board bios without success.
2 replies
by tensasjohnny Accepted solution
Clarifications
by older mycroft Accepted solution
What was the reason?
Were your USB devices already missing before the backup?
As regards the network, since the backup have you run the Network Wizard yet to re-identify the network components to the NEW installation?
If you've [i]"..installed sp2 & sp3.."[/i] then your Backup is as old as Service Pack 1. Did you install your system Drivers [b]BEFORE[/b] SP2 & SP3 (which are only updates to existing drivers)?
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies