Question Locked

Updated BIOS limits RAM

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a AOpen MX46-533V Motherboard. It has two PCI slots, each capable of reading 1 GB of RAM in each slot. I have recently purchased 2 1GB RAM sticks 184pin DIMM DDR PC3200 from crucial.com. I have updated the BIOS by going to the A Open website. No matter what I place in each slot, I get a max memory of 512 MB. It is incredibly frustrating. I have already tried two vendorsm, had one vendor replace the first one I tried. I've been on the phone with tech support at Microsoft, Crucial, AOpen, and 4Allmemory.com. AOpen states the memory may not be compatible, Crucial and 4Allmemory state that Windows may be limiting the memory. (I checked the Maxmemory command and it's not) Microsoft says it's the BIOS system not recognizing the memory. I tend to think it's the latter of all three. I've updated the BIOS to it's latest version; however, so I have no idea what to do at this point. Can anyone give me a suggestion? Thanks.

5 replies

by p.j.hutchison

First, you do not fit memory in PCI slots, they go into memory slots.
Second, that board supports PC2700 and not PC3200 according to AOpen web site. Maybe you need to change the RAM chips or reduce the speed of the RAM to match the motherboard in BIOS settings.

by amhildebrandt

Sorry about the PCI slip. I know where to put them. The first memory stick I received from 4allmemory.com was a PC2100 and I still had the same issue. Should't it support PC2700 and below? I ordered the PC3200 after the people that built our office's computer systems told me to order them. I forgot to state this: I place 1 GB RAM in one slot and a 256 MB in the other, I still only get 512 MB. I used to have a 256 and a 128 stick; which gave me 384 MB total. It's like the BIOS is "stuck" on 512. Does that information help any?

Edit: I have changed the RAM chips around before. I tried them in both slots. How do I reduce the speed of the RAM in the BIOS settings? I'm a quick learner, I just don't know what to do.

by jamesrl

I had a PC that took PC2100 and couldn't find any. Everyone here assured me it was ok to put faster RAM in the system. I did have issues with one vendors"generic" RAM, but when I returned it and went to Kingston Value RAM, everything was fine even though the RAM was higher speed. Since then I've done this a few times in other machines, its not a problem to user higher speed RAM.

James

by thechas

It sounds like what you have is a memory density problem. Specifically, the hardware and not just the BIOS on your motherboard cannot address memory modules that have memory ICs of more than "X" density.

What you need is older memory modules with more devices on them.

Count the number of large ICs on your 256MB DIMM. A 1GB DIMM that would have the best chance of being compatible with your system would have either 2 or 4 times the number of memory chips.

While Crucial is a good brand of memory, when I am concerned about compatibility issues, I go with Kingston or PNY.

The RAM speed options are under advanced or advance chip-set settings in BIOS.
Generally, the options are grayed out as the system settings usually work just fine.

One final thought, have you performed a clear CMOS since flashing the BIOS?

Very often, BIOS settings will not function properly with a new revision until you clear the CMOS memory.

Chas

This discussion is closed to new replies.