Discussion Locked

Upgrade to Celeron 2.8GHz Doesn't Work

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a system based on a Chyang Fun CFI-S969L motherboard. It was a self-build and I originally built it with a Celeron 1.8GHz CPU and it worked fine.
I recently decided to try to upgrade and bought a Celeron 2.8GHz CPU. The docs with the new CPU say it works on 533MHz FSB. The manual for the motherboard says it suports both 400 & 533 MHz. The BIOS has a setting to detect this and it's set to autoselect (it also set the memory speed and I have 266MHz memory, which is in the supported range for both the slower CPU on 400MHz FSB and the faster 533MHz FSB.
So on paper it looks like it should work, but when I plug it in it doesn't. I don't get anything - blank screen, continous fan noise, no activity from hard drives.
Any suggestions?

3 replies

by willcomp

1 of 2 things most probably. Either BIOS does not support CPU and needs to be updated (try first with old CPU installed) or CPU is kaput.

Apparently you have a FIC ice cube model VG61. I couldn't find any reference to that model on the Taiwan site and ths US site (fica.com) is presently down. Also tried CFI site and your particular mobo is not listed.

Chipset (845G) supports your new CPU.

Good luck

by tim.hedger

I actually have an eCube S968L rather than a FIC. I'll try and get a bios upgrade and see if that works.

by ligurza

I had the same problem when I had an Intel Bayfield motherboard. I got it with an Intel Pentium 4 2.4GHz HT processor with 512k cache. When I upgraded to a 2.8GHz Prescott processor with 1MB cache, the moherboard didn't support. When I phoned the Intel Channel helpdesk in Ireland, they told me that the revision of the board was too low to support the processor. I ended up buying an ASUS P4P800-SE motherboard and it's all good now.

This discussion is closed to new replies.