Discussion Locked

Upgrade to Win 2K

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just upgraded a Micron PC from ME to Windows 2K. There were three compontents that required updated drivers. The NIC, Video, and Sound. THe NIC and Video were no big deal. I found and installed the drivers for 2K without any issues. The sound is another story. The sound is integrated on the motherboard. The board is a GigaByte, GA-7DX. Neither GigaByte nor Micron list a sound driver for this board for 2K. I have installed the latest bios update for the board and still no sound.I have attempedto use some drivers for similar integrated sound cards without sucess. Thoughts, Sugestions?

5 replies

by plg6

Hi!

Took a little digging in the specs, but a Win 2K driver for the sound on your board can be found here: http://www.giga-byte.com/support/d_audio.htm

It depends on the sound chipset used on the board. Looks like you'll be fine for everythingexcept a Yamaha chip based soundcard. They've W2K drivers for every other one used on the board. Of course if Murphy's Law has anything to do with it, you'll have the Yamaha chipset. In that case you may need to do more searching, or, worst case, find out how to disable the onboard sound and get a plug-in soundcard with current drivers. Sometimes drivers just plain don't exist.

by wayne b

I had checked GigaByte's site. According to Micron, the sound chip set used the AD1881 Sound Driver. That driver enabled the sound but increased the frequency to a point that it was like listening to the chipmunks. I took another look at the Win2K upgrade report and found that the unsupported driver was actually a VIA chip set. I downloaded and installed the VIA 686A Audio driver from GigaByte and the sound functions like it should.

by taiseermustafa

Does w2k recongnize the Sound card as PNP, or you should add a new HW manually?
Just to add to above answer, did you check if there is any conflict between the sound card and any other device on the machine, it could be IRQ conflict...,
Did you try to remove the NIC from the PC (If it is not Built in) and try?!
Good luck

This discussion is closed to new replies.