Discussion Locked

upgrading an old PII 350

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I've got a GA_686BX motherboard whitch I think is made by Gigabyte is it possible to move to Plll from the same board and if so how to set the dipswitches on the board ram is no problem cause it goes up to 1 GB

4 replies

by thechas

According to the manual for the GA-686BX, you are limited to a 666MHz PII as the maximum processor.

In addition, your AGP port is a 2X, and your hard drive interface is a UDMA33. Your buss speed is either 66MHz, or 100MHz.

So, you would be much better off with a new motherboard and processor.

You will see more speed improvements with the faster video, drive data transfers, and buss speed than you will get from even trippleing the CPU speed.
Also, if speed is your goal, DDR RAM is showing the fastest test results.

As to memory, what OS are you running or planning to run?
While the theoretical memory wall for W9X is 1023MB, a significant number of systems have trouble with memory above 511MB.
Some tests have shown the W98 actually slows down with more than 196MB of RAM.

by s.lecavalier

went to gigabyte site and found out new bios version up to 800 PIII for that board any comments on that?

by thechas

My comments on PIII 800 and your MB.

I get very concerned when I see conflicting information on a MB mfg web site.

With the lack of detailed information, I would e-mail their tech support and ask specifically what CPUs are supported, and how to set the jumpers.

If the faster CPUs are supported, I suspect that the BIOS doubles the clock speed.
So, I would set the Buss speed to 100MHz, and the multiplier to 1/2 of the CPU clock speed. (3.5 for a 700MHz)

It is also possible that the MB can recognize the CPU, but you can't set the clock speed any higher than 600MHz.

My basic advice still stands. If you double your CPU speed, you will see at BEST a 25% improvement in system performance.

Whereas, a new MB and CPU combo can indeed double the system performance.

by s.lecavalier

I found info on how to set the dip switch to x16 and had confirmation that using socket 370 to slot 1 converter card the board can support all Coppermine P3 cpu directly from Gigabyte

This discussion is closed to new replies.