Discussion Locked

Upgrading Disks on IBM ServeRAID 4Mx RAI

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a server with 5 x 9.1GB SCSI disks which is running out of space. I would like to upgrade to 18GB disks on the same controller, but I am not sure if I can just swap the drives out one by one, and then expand the volume set in NT Disk Administrator. Is this advisable??

4 replies

by timwalsh

It sounds like you are using hardware RAID.

Here are the issues you are bumping up against:

1. While all drives in a hardware RAID array do not need to be the same size, the RAID configuration software will essentialy create drives only as big as the smallest installed drive with the remainder of the space being lost. If you swap out the drives one by one, the RAID controller will rebuild the new drive as part of the array, but will only create the drive as a 9.1GB drive.

2. Usingthe built in software RAID capability in NT, you run into the same problem except that it applies to volumes (partitions). The only way to increase the size of a striped set once it is created is to add free space from an additional drive. Switching the drives one by one will have the same effect as with hardware RAID. The only benefit is that you could eventually create 2 9GB arrays vs. losing the extra space as you would with hardware RAID.

As I see it, your choices are as follows:
1.Back up all your data to tape. Build a new array using the 18GB drives. Restore from tape.
2. Buy a cheap large volume HD. Move all your data from the RAID array to this large-volume drive (temporarily). Create a new array with 18GB drives. Move your data back.
3. If your RAID adapter is dual channel, create a second array with 18GB drives. Move your data.
4. If you are using strictly software RAID (and your SCSI controller can handle the additional 5 drives), create a second array using the 18GB drives, move the data from the older array, and remove the older drives.

Hope this helps.

by timwalsh

Almost forgot the obvious option:
5. You can always continue to increase the size of your present array to the maximum number of drives your RAID adapter can handle.

This discussion is closed to new replies.